More From Contributor

5 Amp low temperature charging cable extension with weather & dirt protected SAE connection system. Features O-03 length: 180 cm / 6 ft O-13 length: 460 cm / 15 ft O-33 length: 100 cm / 40 inch Industry standard 2-pin SAE connector Max. Cable load: 5 A Use at very low temperatures: down to -40 ° C Cable remains flexible at sub-freezing temperatures

Includes:: an in-line rubber gasket for the Opti MATE high performance SAE connector High quality cable, designed by Tec Mate

...

Available

Optimate cable O-128. Weatherproof, long battery cable with charge status monitoring for the 12 V lead-acid battery in your parked car, pickup, boat or motor sports vehicle. Battery status 24-7 with one LED at a glance! Features Length 100 cm, with M8/M10 eyelets suitable for a wide range of battery terminals 15A fuse that protects the cable suitable for -40 °C & the electronics Premium quality! Encapsulated monitor with 4 LEDs indicates battery charge level from full to empty for 12V lead acid batteries (AGM, GEL or STD) The LED corresponding to the state of charge flashes every 3 seconds SAE quick connector for charging the battery when needed

Includes:: weatherproof cap for use while driving Indicates charging system status while engine is running Easy pre-ride check at a glance to determine if battery is charging Operation: 2 automatic modes
- battery level monitoring (single LED flashing mode) & charging system test (arrow mode) Vehicle storage: 4 LEDs cover the "full to empty" vo...

...

Available

Opti MATE cable O-04. Battery clamps with Easy-Grip rubber grips, for round, rectangular (motorsport) & flat poles. Features Length: 50 cm 2-pole SAE connection according to industry standard Max. Cable load: 10 A Use at very low temperatures: down to -20° C With rubber cable seal for Opti MATE heavy-duty SAE connection High quality cable, designed by Tec Mate ...

Available

Opti MATE cable O-14. Battery terminals with 15 A fuse, easy-grip rubber grips, specially designed for round, square (Power Sport) & flat battery terminals. Features Length: 50 cm Industry standard SAE 2-pin connector 15 A fuse Max. Cable load: 10 A Low temperature use: down to -40 °C

Includes:: in-line rubber gasket for Opti MATE high performance SAE connector High quality cable designed by Tec Mate

...

Available

Opti MATE Cable O-27. Reverse the polarity of your SAE 2-pin SAE connector on your standard solar panel & vehicle accessory wiring. Features Length: 15 cm Industry standard 2-pin SAE connector Max. Cable load: 10 A Use at very low temperatures: down to -40 ° C Cable remains flexible at temperatures below freezing point With rubber cable seal for Opti MATE heavy-duty SAE connection High quality cable, developed by Tec Mate ...

Available

Opti Mate O-10 replacement linking shrouds & caps for SAE connectors. Features Fits the Opti Mate two-pin SAE connector plugs

...

Available

Opti MATE cable O-26. 2 x Ø 21 mm car sockets with internal locking slots & cap for 2 x car plug style USB (Universal Serial Bus) chargers or GPS adapters. Features Length: 30 cm 2-pin industry standard SAE plug Max. Cable load: 10 A Use at very low temperatures: down to -40° C The cable remains flexible at temperatures below freezing point High quality cable, designed by Tec Mate ...

Available

Opti MATE cable O-35. Connect your durable SAE battery cable to 2 pieces of heated clothing (jacket / gloves, etc.). Features Length: 30 cm 2 x DC 2.5 mm sockets 2-pin industry standard SAE connector Max. Cable load: 10 A Use at very low temperatures: down to -40 °C Cable remains flexible at sub-freezing temperatures

Includes:: in-line seals for DC 2.5 mm & Opti MATE high performance SAE connectors High quality cable designed by Tec Mate

...

Available

Opti MATE cable O-15. Branching your permanent battery feed line, creating SAE outputs. Features Length: 30 cm Industry standard 2-way SAE connection Max. Cable load: 5 A Use at very low temperatures: down to -20 °C With cable seals & sealing end caps for Opti MATE heavy duty SAE connectors High quality cable, developed by Tec Mate ...

Available

Tecmate OptiMate SAE, Luggage Electrification

OptiMATE cable O-30. Electrify your tank bag or handlebar bag with a cable pass-through or even your fixed luggage cases. Create a weatherproof electrical pass-through from SAE to SAE with a flat profile. Installation is simple. Cut a 14 mm diameter hole through the dedicated crosshair power inlet of your tank bag or handlebar bag, or drill through the hard wall of the case to accept the M14 connector and threaded nut. Custom gaskets are provided for ROUND (Wunderlich) and OVAL (SW Motech) power inputs and for the hard pannier wall. A DC 2.5mm to SAE adapter completes the installation. Features Low profile 90° angle inlet with M14 threaded tube and nylon nut (requires 14 mm hole) Custom seals for ROUND (e.g. Wunderlich) and OVAL (SW Motech) crosshair power inputs and hard pannier wall
External SAE 2-pin connector with inline waterproof seal for optional OptiMATE cable adapter Internal SAE 2-pin connector/adapter for USB or other device Includes DC 2.5 mm connector to SAE adapter and in...

Availability: In Stock
Supplier: Motoin SE
SKU: se-11080592-001

Description Reviews / Comments Add New

Product Description

Opti MATE cable O-30. Electrify your tank bag or handlebar bag with a cable pass-through or even your fixed luggage cases. Create a weatherproof electrical pass-through from SAE to SAE with a flat profile. Installation is simple. Cut a 14 mm diameter hole through the dedicated crosshair power inlet of your tank bag or handlebar bag, or drill through the hard wall of the case to accept the M14 connector & threaded nut. Custom gaskets are provided for ROUND (Wunderlich) & OVAL (SW Motech) power inputs & for the hard pannier wall. A DC 2.5mm to SAE adapter completes the installation. Features Low profile 90° angle inlet with M14 threaded tube & nylon nut (requires 14 mm hole) Custom seals for ROUND (e.g. Wunderlich) & OVAL (SW Motech) crosshair power inputs & hard pannier wall External SAE 2-pin connector with inline waterproof seal for optional Opti MATE cable adapter Internal SAE 2-pin connector/adapter for USB (Universal Serial Bus) or other device

Includes:: DC 2.5 mm connector to SAE adapter & in...

Reviews/Comments

Add New

Jargon Buster

USB - Universal Serial Bus

DC - Direct Current

Nylon - A family of synthetic polymers

Diameter - A measurement across a circle passing through the middle

Cable - A series of wires bonded to form a single thread

Waterproof - Resistant to water, usualy specified by depth in metres

Wall - A physical barrier between two areas

Electrical - Something that requires electricity to work.

USB - Universal Serial Bus. A method of connecting a device to a computer

Simple - Basic, easy no difficulty in understanding.

More From Contributor

Tecmate OptiMate SAE, Luggage Electrification

Product Description

Reviews/Comments

Add New

Intelligent Comparison

Price History

Vouchers

Facebook

Jargon Buster

Supplier Information

Community Generated Product Tags

Contact Us

Information

My Account