Opti Mate PRO-1 DUO. PRO series: 12 V 10 A diagnostic battery charger tester & power supply. Opti Mate PRO-1 DUO, the professional combination charger tester & power supply for powersport & small craft/machine professionals, repair shops & battery retailers. Features Suitable for new or used 12 V lead acid (3-50 Ah) & 12.8 V/13.2 V Li Fe PO4 (2-20 Ah) batteries 3 choices: Choose a charging mode for 12 V lead-acid OR 12.8 V Li Fe PO4, or select power supply mode for battery support during vehicle diagnostics, tuning or troubleshooting Automatic quick battery activation: a flashing green test light indicates that the battery is healthy & sufficiently charged Intelligent recovery mode for deeply discharged batteries, a bad battery is quickly identified, a good battery is charged & then retested Push button activated BMS recovery for Li Fe PO4 batteries Test battery indicator for GOOD (80 to 100%), OK (60 to 80%), & POOR (below 60) Power supply mode provides constant power for vehicle tu... ...

Optimate PRO-4, 4-Bank. The 4-bank battery care center recommended by original equipment manufacturers for the proper activation of NEW batteries & the rescue, charging & testing of neglected batteries/low voltage batteries. Features NEW mode
- 1-hour activation charge only for new batteries filled with acid immediately prior to charging, such as STD wet batteries with removable caps & "dry charged" AGM MF batteries supplied with a special separate acid pack. 2 A-/4 A mode
- max. 12 hours sustained charge mode for diagnosis, rescue, charging, testing sulfated low voltage batteries. Suitable for charging all batteries, including factory activated encapsulated AGM batteries (e.g. Yuasa YTZ, GYZ) prior to sale An informational poster is included with instructions for preparing & charging batteries Banks/charging stations: 4 (each bank works independently) Charging current (per bank): 4A max, Ampmatic control. (2 A max. when 2 A is selected) USE: rooms/workshop environment (lowest...

...

Optimate PRO-8, 8-Channel. The 8-channel battery care center recommended by motorsports original equipment manufacturers for salvaging, charging & testing all 6V & 12V batteries, including neglected sulfated/low voltage batteries. Features Selectable charging voltage
- select 6 V or 12 V battery voltage for each bank. Fully automatic
- No selection required, no battery knowledge needed! Connect up to 8 x 6 V & 12 V batteries & let the charger do the rest! Banks/charging stations: 8 (each bank works independently) Charging current: (per bank): 1 A USE: rooms/workshop environment (lowest temperature: -20 °C) Rescue: start with low voltage of 1.8 V + 1-stage desulfation rescue Ideal for: STD, AGM & GEL 6 V or 12 V batteries of 2 Ah INPUT: Selectable 110-120 VAC / 220-240 VAC 50-60 Hz, with main switch & replaceable fuse Construction: Ventilated industrial table-top case with wall mount (TS-218), 180 cm power cord & 8x 180 cm charging cables with SAE connectors 8x standard battery terminal set included Safety No risk of overcharging Spark suppression Safe for long term battery maintenance Automatic shutdown in case of short circuit or disconnected battery

...

Opti MATE cable O-23. 10 Amp low temperature charging cable extension with weather & dirt protected SAE connection system. Features Length: 460 cm Industry standard 2-pin SAE connector Cable standard: 16 AWG (1.31 mm 2) SPT-2W Max. cable load: 5 A Use at very low temperatures: down to -40 °C Cable remains flexible at sub-freezing temperatures With rubber cable seal for Opti MATE heavy-duty SAE connection High quality cable, developed by Tec Mate ...

5 Amp low temperature charging cable extension with weather & dirt protected SAE connection system. Features O-03 length: 180 cm / 6 ft O-13 length: 460 cm / 15 ft O-33 length: 100 cm / 40 inch Industry standard 2-pin SAE connector Max. Cable load: 5 A Use at very low temperatures: down to -40 ° C Cable remains flexible at sub-freezing temperatures

Includes:: an in-line rubber gasket for the Opti MATE high performance SAE connector High quality cable, designed by Tec Mate

...

5 Amp low temperature charging cable extension with weather & dirt protected SAE connection system. Features O-03 length: 180 cm / 6 ft O-13 length: 460 cm / 15 ft O-33 length: 100 cm / 40 inch Industry standard 2-pin SAE connector Max. Cable load: 5 A Use at very low temperatures: down to -40 ° C Cable remains flexible at sub-freezing temperatures

Includes:: an in-line rubber gasket for the Opti MATE high performance SAE connector High quality cable, designed by Tec Mate

...

Optimate cable O-128. Weatherproof, long battery cable with charge status monitoring for the 12 V lead-acid battery in your parked car, pickup, boat or motor sports vehicle. Battery status 24-7 with one LED at a glance! Features Length 100 cm, with M8/M10 eyelets suitable for a wide range of battery terminals 15A fuse that protects the cable suitable for -40 °C & the electronics Premium quality! Encapsulated monitor with 4 LEDs indicates battery charge level from full to empty for 12V lead acid batteries (AGM, GEL or STD) The LED corresponding to the state of charge flashes every 3 seconds SAE quick connector for charging the battery when needed

Includes:: weatherproof cap for use while driving Indicates charging system status while engine is running Easy pre-ride check at a glance to determine if battery is charging Operation: 2 automatic modes
- battery level monitoring (single LED flashing mode) & charging system test (arrow mode) Vehicle storage: 4 LEDs cover the "full to empty" vo...


...

Opti MATE cable O-04. Battery clamps with Easy-Grip rubber grips, for round, rectangular (motorsport) & flat poles. Features Length: 50 cm 2-pole SAE connection according to industry standard Max. Cable load: 10 A Use at very low temperatures: down to -20° C With rubber cable seal for Opti MATE heavy-duty SAE connection High quality cable, designed by Tec Mate ...

Opti MATE cable O-14. Battery terminals with 15 A fuse, easy-grip rubber grips, specially designed for round, square (Power Sport) & flat battery terminals. Features Length: 50 cm Industry standard SAE 2-pin connector 15 A fuse Max. Cable load: 10 A Low temperature use: down to -40 °C

Includes:: in-line rubber gasket for Opti MATE high performance SAE connector High quality cable designed by Tec Mate

...

Opti MATE cable O-30. Electrify your tank bag or handlebar bag with a cable pass-through or even your fixed luggage cases. Create a weatherproof electrical pass-through from SAE to SAE with a flat profile. Installation is simple. Cut a 14 mm diameter hole through the dedicated crosshair power inlet of your tank bag or handlebar bag, or drill through the hard wall of the case to accept the M14 connector & threaded nut. Custom gaskets are provided for ROUND (Wunderlich) & OVAL (SW Motech) power inputs & for the hard pannier wall. A DC 2.5mm to SAE adapter completes the installation. Features Low profile 90° angle inlet with M14 threaded tube & nylon nut (requires 14 mm hole) Custom seals for ROUND (e.g. Wunderlich) & OVAL (SW Motech) crosshair power inputs & hard pannier wall External SAE 2-pin connector with inline waterproof seal for optional Opti MATE cable adapter Internal SAE 2-pin connector/adapter for USB (Universal Serial Bus) or other device

Includes:: DC 2.5 mm connector to SAE adapter & in...

...