Opti MATE cable O-127. Permanent power sport battery lead with integrated battery status / charge system monitor for 12.8 / 13.2V lithium batteries. Weatherproof battery lead with state of charge monitor for the 12.8 V/13.2 V Life PO4 / LFP battery in your parked performance vehicle – 24-7 battery status at a blink of an LED! Smart battery cable that measures voltage, monitors charge of a stored 12 V Lithium (LMi Fe PO4) battery & confirms if the vehicle charging system is working correctly. Features Length: 24″/60 cm Battery connector: 1/4″ (M6) / 5/16” (M8) ringlets Charge connector: 2-pin SAE, protected from dirt & liquid with rubber sealing cap & shroud Operation: 2 automatic Modes – Battery charge level monitor (single LED blink mode) & Charging system test (arrow mode) Vehicle storage: 3 LEDs display ‘full to empty’ voltage range for 12.8 V/13.2 V Lithium batteries (LFP/ Li Fe PO4/ Lithium nano Phosphate), 4th LED warns when vehicle system or connected battery charger is OVERCHARGI... ...

Opti MATE cable O-124. Permanent power sport battery lead with integrated battery status / charge system monitor for 12 V lead-acid batteries. Weatherproof battery lead with state of charge monitor for the 12 V lead-acid battery in your parked powersport vehicle – 24-7 battery status at a blink of an LED! Confirm if the vehicle charging system is working or battery is charged & provide emergency roadside light, powered via your permanent battery lead or an optional motorbike/AUTO socket accessory. Features Length: 24″/60 cm Battery connector: 1/4″ (M6) / 5/16” (M8) ringlets Charge connector: 2-pin SAE, protected from dirt & liquid with rubber sealing cap & shroud Operation: 2 automatic Modes – Battery charge level monitor (single LED blink mode) & Charging system test (arrow mode) Vehicle storage: 4 LEDs cover ‘full to empty’ voltage range of all 12 V batteries, including higher voltage AGM for power sport (4th √√LED ≥ 12.7 V ). LED matching charge level blinks every 3 seconds (long... ...

Opti MATE cable O-11. High quality permanent battery lead with quick disconnect for automotive/boat batteries, with weatherproof connection system & cable. Features Length: 50 cm M8 eyelets Industry standard 2-pin SAE connector 15 A fuse Max. Cable load: 10 A Use at very low temperatures: down to -40 °C Cable remains flexible at sub-freezing temperatures Rubber sealing cap & sheath for Opti MATE heavy-duty SAE connector High quality cable, developed by Tec Mate ...

Opti MATE cable O-57. Converts the MV Agusta specific battery charging port under the seat (on newer models) into an industry standard 2-pin SAE connector. Features Length: 30 cm MV Agusta >2010 connector Industry standard 2-pin SAE connector 15 A fuse Max. Cable load: 5 A Use at very low temperatures: down to -40 °C Cable remains flexible at sub-freezing temperatures With sealing cap for Opti Mate heavy-duty SAE connector High quality cable, developed by Tec Mate ...

Opti MATE cable O-37. Monitor your vehicle s battery status with O-122/123/125 via the OBDII port or maintain your battery (low current). Features Length: 100 cm Industry standard 2-pin SAE connector Max. Cable load: 10 A 15 A fuse Use at very low temperatures: down to -40 °C Cable remains flexible at sub-freezing temperatures Closure cap for Opti MATE SAE high performance connector included High quality cable, developed by Tec Mate ...

Opti Mate Cable O-40. M18 SAE flush mount socket to be installed in the instrument panel, with cable terminating in a SAE plug. The 18 A / 0.82 mm² cable is rated down to -40 °C, so it is ideal for permanent installation on a vehicle that will be used in cold weather. The socket can be used as a replacement for the more expensive DIN socket & plug system (" Hella"), which is common on BMW, Triumph, Victory & now on some Ducati motorcycles. Connection to the battery requires a battery cable that terminates in an SAE connector, such as the weatherproof Opti Mate O-01 battery cable. Features O-40S cable length 15 cm
- perfectly adapted for Harley Davidson
- short cable length for easy connection to existing HD SAE cable O-40 cable length 100 cm Front panel mount with rear fastener Connector body fits a Ø18mm (23/32”) drilled hole. Industry standard durability – Built to last! Perfect for use in the harshest environments, Low temperature use -40°C/-40°F – Remains Flexible!

...

Opti MATE cable O-125. SAE to SAE adapter with state of charge monitor that connects directly to the SAE battery lead fitted to the 12 V battery in your parked powersport vehicle – 24-7 battery status at a blink of an LED! SAE connection system fits any SAE standard 2-pin connector,

Includes:: in-line seal that mates with Opti Mate SAE – Premium quality! Sealed monitor with 4 LEDs indicate battery state of charge from full to empty for 12V lead-acid (AGM, GEL or STD) batteries – LED corresponding to charge level blinks every 3 seconds. SAE quick connect charge port for charging battery when needed – with weatherproof sealing cap when vehicle is moving! Displays charge system status when engine is running – easy pre-ride check at a glance to see if battery is receiving charge. Features Length: 6″/15 cm 2-pin SAE connectors, protected from dirt & liquid with rubber sealing cap & shroud 2 automatic Modes – Battery charge level monitor (single LED blink mode) & Charging system test (arrow mo...

...

Opti Mate O-108 V2. The fully enclosed SAE to USB (Universal Serial Bus) 3300 m A charger with 200 cm cable allows safe & fast USB (Universal Serial Bus) charging of any device mounted on the outside of the handlebar or in your tank bag or hard case. The cable goes where USB (Universal Serial Bus) charging is required. Charge your phone, GPS, camera & tablet with your weatherproof charger on your motorcycle or up to 80″ / 200 cm away from a 12 V supply. Features Connects to battery cable with industry standard 2-pin SAE connector Inline gasket makes 12 V connection weatherproof! Charges 1x USB (Universal Serial Bus) device with up to 3300 m A current (or optionally charge 2 devices with O-110 USB (Universal Serial Bus) splitter). Charging current adjusts to connected device for safe charging. Weatherproof USB (Universal Serial Bus) charging port, easily attaches to handlebar, fork or brake/clutch fitting with cable tie USB (Universal Serial Bus) cable inserted is sealed, for charging in all weather conditions Built-in protection interrupts USB (Universal Serial Bus) charging & prevents your parked vehicle s LFP (Li Fe PO4) or AGM (Pb) battery from discharging Resta... ...

Opti MATE Solar, the world s most efficient solar pulse charging system that protects your battery & provides safe long-term maintenance. Saves deeply discharged batteries while still at 4 volt with the unique pulse function. Fastest charge
- occurs as the intelligent charge function selects pulse or continuous charge depending on the intensity of sunlight. Intelligent maintenance
- continues the next day if a battery has held charge overnight, otherwise the program switches back to the OPTIMIZE step. Battery status is displayed every 3 seconds. Ready indicator for STD & high capacity AGM batteries. Draws less than 0.5 m A in monitoring mode. Automatically switches to CHARGE when solar intensity is sufficient. Opti MATE charge controller is separate from the panel & can be placed close to the vehicle or battery for easy tracking of charging & maintenance progress. The solar panel must be mounted & oriented to receive direct sunlight. The range/distance between the battery & the panel is 315 cm. For extension, use Opti MATE extension cables O-03, O-13 or O-23 & connect it to the solar panel & Opti MATE charge controller. Weatherproof charge controller housing with mounting holes & loops (for Velcro or zip tie). SAE input connector for solar panel & output cable of 100 cm connected to the battery with the supplied weatherproof battery cable & standard battery terminal kit. No risk of overcharging. Completely safe for vehicle electronics. Spark suppression. Safe for long term battery maintenance. Automatic shutdown in case of short circuit or disconnected battery. Solar panel POWER: 10 watts (max) Voltage: 12V / 12.8V Outdoor use Weatherproof polycrystalline aluminum frame with 4 mounting brackets. Outside dimension, including corner brackets: Width = 24.9 cm / 9.8" Height = 37.6 cm / 14.8" Depth = 2.6 cm / 1" Output cable 200 cm / 80" with SAE connector Opti Mate charging/monitoring controller Charging current: 0.83A from 10W panel (max. average current), 3-5A pulse current Indoor/outdoor use (lowest temperature: -4°F / -20°C) Rescue mode: start with low 4V voltage Suitable for: STD, AGM & GEL 12V batteries from 2
- 240 Ah & Lithium LFP 12-8V-/13.2V batteries. Input: 15
- 22V Design: weatherproof charge controller case. Scope of delivery Weatherproof battery cable Standard battery terminal set 10W solar panel Safety No risk of overcharging Completely safe for vehicle electronics Spark suppression Safe for long-term battery maintenance Automatic shutdown in case of short circuit or disconnected battery



...

Opti Mate TS-120. 12 V tester for battery state of charge, cranking performance & vehicle charging system. The ultimate pocket tester for on-vehicle battery performance & alternator voltage testing with either 12 V lead-acid or 12.8 V Li Fe PO4 starter battery – easy troubleshooting from cranking to charging! Features For vehicles fitted with 12V AGM, GEL & STD lead-acid or 12.8V LFP / Li Fe PO4 starter battery As easy as 1-2-3, connect to battery, check state of charge, start engine tester displays cranking voltage & vehicle charge voltage simultaneously – 15 sec is all you need! Display cranking volts down to 6V & charge voltage range up to 15 V – Check weak battery or overcharging Easy to use! Connect with the included clips to the battery or connect to an installed SAE battery lead Length: 40″/100 cm Charge connector (input): 2-pin SAE (+set battery clips) Operation: fully automatic State of charge result in GREEN / RED LED resuls, indication of lowest start Volts when engine st... ...